Serving all of Seattle · Open every day, 7am-9pminfo@alkiroofrepair.com
Typical range: see below · free quotes

Gutter Leak & Overflow Repair in Seattle

Illustration of rain overflowing a clogged gutter against a house fascia

Gutters are the most underrated part of a Seattle roof system. When they work, nobody thinks about them. When they clog, sag, or split, they pour concentrated roof runoff exactly where it does the most damage: down the fascia, behind the siding, and into the crawlspace or basement.

A Seattle roof sheds a startling amount of water — a modest 1,500 square foot roof moves nearly a thousand gallons through its gutters in a single inch of rain. Our long soaking storms mean an overflow doesn't splash for ten minutes; it runs against the house for two days.

This service covers the repairs that keep that water moving where it should: resealing split seams and end caps, releveling sagging runs, re-securing pulled hangers, repairing or re-routing downspouts, and fixing the fascia rot that failed gutters leave behind.

Signs this is your problem

  • Water sheeting over the gutter edge in normal rain
  • Drips from gutter seams or end caps after rain stops
  • Gutters visibly sagging or pulling away from the fascia
  • Peeling paint or soft wood on the fascia board behind the gutter
  • Trench or splash erosion in beds under a gutter line, or a chronically damp basement wall

How the repair works

  1. Clear and flow-testGutters and downspouts cleared, then water-tested to see exactly where flow fails.
  2. Reseal and re-secureSeams, corners, and end caps resealed; hangers replaced and runs re-leveled to drain properly.
  3. Downspout repairCrushed, disconnected, or undersized downspouts repaired or re-routed away from the foundation.
  4. Fascia checkRot behind failed sections gets flagged with photos, and small fascia repairs handled while access is set up.

What it costs

Gutter repairs in Seattle typically run $250 to $900. Full cleaning with resealing sits at the low end; releveling long runs or repairing fascia sections pushes toward the high end. Full gutter replacement is quoted separately when repair genuinely isn't worth it.

The Seattle factor

Seattle's needle load makes standard leaf guards a mixed bag — fir needles thread through many of them. Homes under conifers in Wedgwood, Ravenna, and North Beacon Hill often do better with twice-yearly clearing than with covers, and you'll get an honest read on which makes sense for your trees.

Gutter Leaks: your questions

Are my gutters causing my basement water problem?

Very possibly. Overflowing or disconnected gutters are among the most common causes of wet Seattle basements. Fixing an $400 gutter problem beats a $15,000 waterproofing project, so it's the right thing to rule out first.

Can leaking gutter seams actually be sealed, or is that a band-aid?

Aluminum gutter seams reseal well when the metal is sound and the joint is cleaned and prepped properly. If the run is rusted through or the metal is fatigued, resealing is a band-aid, and you'll be told so.

Do you install gutter guards?

Where they make sense for your tree cover, yes. Under heavy conifer needle load, some guard products cause more problems than they solve, and honest advice sometimes means recommending against them.

How often should Seattle gutters be cleaned?

Twice a year for most homes — after the fall drop and after spring pollen and seed drop. Homes under mature evergreens may need a third visit, since conifers shed year-round.

Water where it shouldn't be?

Call now for a fast, free quote. Active leaks get same-day priority.

Call (206) 206-0444 Free Quote